JDM EJ25 Engine swap no Start
New to the forum and Subaru family so.... please pardon my ignorance. So, here's my issue. I bought a 2009 Forester with a locked up engine. Purchased a JDM to replace it. dropped it in everything went in fine. I have a crank but no start situation. I used the throttle body off of the original engine because it was much cleaner. I relocated a couple of vacuum ports bc donor was on the wrong side. Replaced the timing belt and idlers. Replaced a 15 amp fuse in #12 slot in the inside panel (no crank-no start before that). Any suggestions on where to go from here?